The Clock.
Wall mounted.
It needs a power supply (cable).
Table mounted. Table placed.
Beauty on every table, cupboard or shelf.
Motors and electronic.
Final upgrades are coming soon!
Random 1.
Gears.
Buttons for time setup.
Also, final upgrades are coming soon!
Clean and shiny.
Can't stopwatching uh?
Renders
Some fancy 3D renders of the clock.
holder
hmc
lay_down
try5.JPG
multikolor3.JPG
multikolor2.JPG
clock4.JPG
multikolor.JPG
clock3.JPG
clock2.JPG
clock.JPG
Electronics
These are all versions of electronics we’ve been either making or at least planning to make.
v6
v4
v5
v2
v3
IMAG0627
IMAG0625
No comment.
IMAG0624
This version is neat and working on Arduino (Atmel). We still have some spare pieces, if anyone needs one. 🙂
IMAG0623
The first printed circuit board. The thin wires above holes were supposed to serve as calibration contacts, but we have all given up on aligning the shashed wires over and over again.
IMAG0621
This is not a circuit at all. This too-much-confused version didn't get its own.
Old Designs
There’s not much to show. We haven’t been very merciful to failed attempts.
plexiclock
clock-1
ura Copy.Still013
ura Copy.Still015
ura Copy.Still014
old2
old1
Video.
ura Copy.Still008
ura Copy.Still007
ura Copy.Still006
ura Copy.Still002
ura Copy.Still037
ura Copy.Still021
ura Copy.Still020
ura Copy.Still018
You can find aditional pictures at The Story and The Clock.
We will be adding more images in the future, so check this page from time to time!